Hello everyone! This is Brittany from Va-Voom Vintage here, to show you how to sew a 1940's hair scarf. I am so excited to be a part of the guest blogging series while Stephanie is on vacation!
This is a great project to use some of that scrap fabric in your stash. You can use pieces of vintage sheets, feed sack, table cloths and other household linens. Today's tutorial uses shirring. Shirring is very easy to do and looks fantastic!
For my scarf, I'm using a scrap of vintage cotton but you can use all sorts of fabric as long as it's light enough to shirr. I tried to use a very thin clear vinyl to make a rain bonnet but sadly, the plastic didn't want to cooperate.
Supplies
22 inch by 13 inch rectangle of fabricelastic thread (I'm using Gutterman elastic thread in black)
matching or contrast thread (which will appear on the right side of your fabric)
40 inches of ribbon of your choice (I used a strip of pink satin bias tape from my stash)
a sewing machine
scissors
an iron
sewing pins
Begin with your fabric 22 inches long and 13 inches wide. You can use a thinner piece of fabric to make a basic headband but this wider piece will create a little pouch to hold your hair when you're finished.
Make a hem on each long side of the fabric. Turn the hem under 1/4 inch and press. Turn 1/4 inch once more, pin into place and sew.
Wind elastic thread by hand around your bobbin. It sounds like tedious work but since the elastic is thicker than regular thread the hand-winding goes pretty quickly. Be sure to keep a slight tension on the thread as you wind but be careful to not pull it tightly.
Insert the bobbin and thread the machine as you would with any other thread.
Using a fabric marking pen or pencil, mark the right side of fabric. Draw dotted lines 1 1/2 inches apart from each other along the long edge of the fabric. If you want your scarf to be more tightly shirred, space the lines closer together.
Using the markings as a stitching guide and with the right side up, sew a straight line through the first dotted line.
Sew the remaining lines of shirring, pulling the fabric so it lays flat as you sew. This way, the shirring will be tidy and the amount of gathers will be even. As you sew more lines of shirring, the fabric will gather more.
The elastic thread should be on the wrong side of the fabric. Trim all loose threads
Turn in the hem of the short sides, again 1/4 inch. Pin and sew, trim loose threads.
Next, set your machine to the long stitch setting to make gathers
Sew a straight line along the short edge of the fabric at about 1/4 inch from the edge, leaving excess threads long. Repeat on the other side.
Pull the bobbin thread to make a gather. Gather each side of the fabric as tightly as you can and tie the loose threads to secure the gathers in place.
Snip your ribbon in half. On wrong side of fabric pin one piece of your ribbon like so:
stitch into place, trim loose threads.
Flip the ribbon to the other side, pin in place and sew. Trim loose threads.
.
Attach ribbon on the other side in the same manner. Trim all loose threads and enjoy your new head scarf! If you have any questions, just ask!
Thank you to Stephanie for having me. I can't wait to see pics and hear all about your vacation when you come home!!
